Guide :Radio Communications : (AHS-322) Headset

My mic is broken, so I tried to fix the headset by cutting the wires. Then I striped the wires. But I noticed that there were only 4 wires, yet there were 5 places to solder. Looking at the part, There are 3 connected wires that I have not cut off yet and there is 1 wire broken. That leaves 1 wire and 2 soldering spots unaccounted for. When I look at the 2 soldering places, they both have a small strand there, so I can not tell which one the wire broke off of. I tried searching online to find the blueprint of Altec Lansing AHS322, but I had no luck. I just need to see where the wires go. Does anyone have any ideas?

Posted by bob bob on May 21, 2007

Research, Knowledge and Information :



We did not find results for: my mic is broken so i tried to fix the headset by cutting the wires then i striped the wires but i noticed that there were only 4 wires yet there were 5 places to solder looking at the part there are 3 connected wires that i have not cut off yet and there is 1 wire broken that leaves 1 wire and 2 soldering spots unaccounted for when i look at the 2 soldering places they both have a small strand there so i can not tell which one the wire broke off of i tried searching online to find the blueprint of altec lansing ahs322 but i had no luck i just need to see where the wires go does anyone have any ideas.

Loading ...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || dick-van-dyke.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0345 seconds